Making patterns for the bottom of the floor bearers so that a floor can be laid down while working on the inside of the dinghy
A number of patterns made, now just have to line them up in the boat and mark off the tops
Using a piece of plywood to work on in the dinghy at the moment, however soon to be replaced with floor bearers and a temporary floor
The dinghy also ribbed out just the fron few to do when I get my next green oak shipment
Time to take a look at the plans and see what can be done while waiting for my next timber shipment
Making patterns for the breasthook
Also take a look at making the mast step and mast thwart as well
Patterns made for the knees and breasthook
It is now time to start to think about putting the ribs in and then the breasthook and transom knees in and then the gunwales
Just this last mould station to remove and the technical bit of fitting the inside of the dinghy out with all its seats centreboard etc…
A large space at the moment but it will not take long to fill up with the parts needed to make it into to a sailing dinghy.
Finally all the nails are in and done now comes the fun bit steaming in the ribs.
Finally the last plank is now being fitted
The final rebate being cut and the plank being fitted to the stem
The first of the moulds been removed as the plank is nailed in place.
The second mould now removed and
finally the lot are removed to leave a big void to fill with centreboard case and seats and mast step
Looking up towards the stem after four of the twenty ribs have been steamed into position
The job was to get the last piece of green oak I had around and plane it to thickness ready to cut it up to the correct size.
There is the plank all cut up and put through the thicknesser ready to have the edge bevelled ready to get fitted
Halfway through the bundle of ribs just another ten more to go.
Almost there now ready to steam them in next week.